Skip to content

Forestry and Parks - Request for Quotes - Boreal Centre Cable Truss Lift

16 days leftSource: APC
Issuing body
Forestry and Parks
Location
Alberta
Closes

Get tenders like this one matched to your trade and emailed to you. Free.

A morning email when new tenders match your trade and province. No credit card.

Get matched free

Bidding on this one? Send us your draft and the tender documents: for CA$450 we check it against what is mandatory and what is scored and fill in the forms, back to you within 48 hours. How the compliance pass works

Trades

Scope

Organization: Forestry and Parks PROJECT BACKGROUND: The BCBC (Boreal Centre for Bird Conservation) is a Gold Leeds building that incorporates an inverted roof supported by Glue Lam Beams and ½ Cable Trusses. Winter snow load was very excessive stretching the cables, lowering the center of the inverted roof line by 4 inches. PROJECT OBJECTIVE: Raise the trusses and tighten the threaded swage connecters at each cable end to lift the roof back into place. SCOPE OF WORK: Contractor is responsible for all necessary equipment, tradesmen, and supplies for the completion of the following scope of work: 1. Blocking to be installed between the individual top chord 2x8 members. Blocking will be spaced no further than 1.5m apart along the length of the top chords. Blocking to be installed prior to raising the trusses with oversight from a professional engineer, supplied by parks. 2. Shore each truss at the mid-span to incrementally lift trusses a total of inches vertically. Shoring to be raised so that adjacent trusses are lifted simultaneously, avoiding differential height changes of more than 2 inches between adjacent trusses. 3. Cables to be tightened while the trusses are slowly raised, equally at each end of the truss. Tighten each cable one-half rotation before tightening the next cable to maintain equal tension between cables. The cables are to be tightened slowly and evenly until load on the shoring has been reduced, this is tested by dropping the shoring slightly, the truss should settle only slightly once the cable has reached an ideal tension. 4. This procedure will be overseen by a professional engineer supplied by Parks. All debris and garbage disposal is the responsibility of the contractor. Submission: Refer to the RFQ document for specific instructions on submitting a quote - please read carefully to ensure all required information and documentation is included in your submission. Note: The contractor is to provide a preliminary construction sch

Cornerstone Contracts aggregates this notice. The issuing authority publishes the official documents and is the only authoritative source for requirements and deadlines.

View the official posting

First listed October 20, 2026

Other open roofing tenders in Alberta

See all open Alberta tenders

Want tenders like this scored to your trade?

Cornerstone scans Canadian public tenders daily and scores each one against your trade, province and bonding capacity. Free to browse.

Get matched